STEREO TUBE PREAMPLIFIER MM-LINE 

MODEL: V P 0 4


The desing of this tube preamplifier uses only two tube for channel-stage:
one pair off ECC 81 low noise for phono section and one pair off ECC 82 for line stage and output cathode follower for to have low impedance output.
The architecture design don't incorporate negative feedback,the phono section adopt passive RIAA equalization with precision components at 1% and special optoelectronic cathode coupled semiconductor bias control.
High level stage is optimized for C.D. and DAT source,better control is possible with interface board card model IBXVP04 (optional).
The power supply is regulated by I.C. using Mosfet transistor and employ only high quality electrolitic capacitors,metal foil resistor; the ground circuity use star point configuration with hard wire made.
Active and passive electronic components are only premium grade:

The results is a great soundstage: hi-dinamic,detailed,transparent sound.....a perfect sound illusion!!!

CONVENIENCE AND PERFORMANCE

Optional plug-in card to fit inside the VP-04:

SPECIFICATION

Input sensibility phono: 1.5 mV 47k 100pF
line: 200 mV
RIAA precision 0.5 db
Distorsion 0.1% THD
Preamplifier gain total phono-out 60 db
Frequency response 20-20Khz
Output impedance 290 ohm 20V rms
Power supply 220vac-240vac

110vac 35va

Dimension 400 x 85 x 300 (l x h x p)
Weigh net 6.5 kilos

Back to the Lector-home page


DOCET-LECTOR - Via Cairoli, 116 - 27010 Albuzzano (PV) - Italy
Voice:+390382-484165 Fax:+390382481021---- e-mail: info@docet-lector.com


HI-END AUDIO / HI-FI / HOME THEATER / TUBE-VALVE HYBRID TECHNOLOGY